Installation guide

Programming Options
MODE 1 * INDICATES DEFAULT SETTING
FUNCTION 1 – Ignition-controlled door locks
OPTION 1* Ignition lock DISABLED
OPTION 2 Ignition lock ENABLED
OPTION 3 Ignition unlock ONLY
OPTION 4 Ignition lock ONLY
FUNCTION 2 – Secure lock
OPTION 1* Secure lock DISABLED (1-sec. disarm pulse)
OPTION 2 Smart secure lock ENABLED in smart mode
OPTION 3 Secure lock DISABLED (1/2-sec. disarm pulse)
OPTION 4 Standard secure lock ENABLED in standard
mode
OPTION 5 Standard secure lock ENABLED (no rearm
pulse when ignition is ON)
FUNCTION 3 – Passive or active arming
OPTION 1* PASSIVE arming (60 sec.)
OPTION 2 ACTIVE arming
OPTION 3 PASSIVE arming (3 min.)
FUNCTION 4 – Door lock pulse timing
OPTION 1* 7/10-sec. lock/unlock pulses
OPTION 2 4-sec. lock/unlock pulses
OPTION 3 7/10-sec. lock pulse and two 1/4-sec. unlock
pulses
OPTION 4 1/10-sec. lock/unlock pulses
FUNCTION 5 – LED flashing
OPTION 1* ENABLED (without starter kill Æ will flash
only when ignition is OFF)
OPTION 2 DISABLED
OPTION 3 ENABLED (with starter kill Æ will flash when
the starter kill engages. This option should be
selected ONLY if the starter kill is installed.)
MODE 2 * INDICATES DEFAULT SETTING
FUNCTION 1 – Safe start.
OPTION 1 safe start ENABLED
OPTION 2* safe start DISABLED
OPTION 3 “Swap Start” – enhanced safe start mode with
extended safety: To start the engine: press the
SHIFT and LOCK buttons simultaneously.
To trigger AUX 2: press the START/STOP
button
FUNCTION 2 – Engine Run Time
OPTION 1 run time = 4 minutes in GAS mode / 9 minutes
DIESEL mode
OPTION 2* run time = 15 minutes in GAS mode / 20
minutes DIESEL mode
OPTION 3 run time = 25 minutes in GAS mode / 30
minutes DIESEL mode
FUNCTION 3 – Idle/Turbo Mode
OPTION 1 Idle/turbo mode DISABLED
OPTION 2* Idle/turbo mode ENABLED
OPTION 3 Idle/turbo mode DISABLED
FUNCTION 4 – Engine Type and Cold Weather Mode
OPTION 1 Diesel mode with 20-minute run time in cold
weather mode (30-sec delay)
OPTION 2* Gas mode with 4-minute run time in cold
weather mode (1-sec delay)
OPTION 3 Diesel mode with 9-minute run time in cold
weather mode (7-sec delay)
OPTION 4 Diesel mode with 9-minute run time in cold
weather mode (15 sec delay)
FUNCTION 5 – Ignition Valet
OPTION 1 ignition valet DISABLED
OPTION 2* ignition valet ENABLED
OPTION 3 ignition valet ENABLED
MODE 3 * INDICATES DEFAULT SETTING
FUNCTION 1 – Home Valet TM
OPTION 1 Home valet ENABLED
OPTION 2* Home valet DISABLED
OPTION 3 Home valet DISABLED
FUNCTION 2 – AUX 3 / Zone 3 Programming
OPTION 1 1-sec. output when TRUNK button is pressed
for 3 sec. with ignition OFF or under remote run.
OPTION 2* Constant output while the TRUNK button is
pressed.
OPTION 3 Disarm/rearm pulse with TRUNK
FUNCTION 3 – AUX 2 Programming
OPTION 1 Constant output while the SHIFT and LOCK
buttons are pressed. In safe start mode:
activate AUX 2 by pressing the START/STOP
button.
OPTION 2* Toggle ON/OFF (with 30-second timeout)
OPTION 3 4-minute toggle (only when running under
remote start)
OPTION 4 Priority door access
FUNCTION 4 – AUX 1 Programming
OPTION 1 Horn confirmation upon the 2nd press of the
LOCK button.
OPTION 2* Priority door access
OPTION 3 Horn confirmation upon the 1st press of the
LOCK button.
FUNCTION 5 – External Trigger
OPTION 1 Zone 3 rearm (trunk pin: a disarm pulse is sent
before the trunk opens, the vehicle rearms
4 seconds after the trunk is closed).
OPTION 2* Engine start/stop
OPTION 3 Key sense
OPTION 4 Dome light smart ignition lock
MODE 4 * INDICATES DEFAULT SETTING
FUNCTION 1 – Multi-Level Features
OPTION 1 Multi-car Features, Basic Features, Customized
Features
OPTION 2* Basic Features, Multi-car Features,
Customized Features
OPTION 3 Customized Features, Multi-car Features, Basic
Features
OPTION4 Basic Features, Customized Features, Multi-
car Features
AS-2520TW
Programming Options and Wiring Diagram