Specifications

1-32
1.14.2 M2007 Useful Codes
To enter any of the following codes: Press and hold 3and 4simultaneously for TEN seconds and a
three chirps sound. Release the buttons and code appears.
• Reset Factory Menu - Enter 3322. The computer display flashes and quickly counts
from 1-40 and switches to off. (NOTE: This will delete any hand-entered menu items).
• Switch between Domestic Menu and International Menu - Enter 1212.
• Reset CALL TECH Message - Disconnect board locator plug (J10). Reinsert plug. Enter
1000. Computer display switches to off. Remove and then restore power to the
computer using the 20-pin plug. If this message appears at any time other than after upgrade
from version 47, replace the computer.
• Reset BADCRC Message - Disconnect board locator plug (J10). Reinsert plug. Enter
9988. Computer display switches to off. Remove and then restore power to the
computer using the 20-pin plug.
• Change from F° to C° - Enter 1658. The computer displays off. Turn the computer on
and check temperature to see the temperature scale. If the desired scale is not displayed,
repeat.
• Enter Tech Mode – Enter 1650.
• Readdress LOV™ configuration after changing an MIB board – Enter 2007.
• Reset RECOVERY FAULT CALL SERVICE – Enter 0042.
PASSWORDS
To enter level one, level two passwords: Press and hold the TEMP and INFO buttons simultaneously
until level 1 or level 2 is displayed. Release the buttons and ENTER Code appears.
• Fryer Setup, Level One and Level Two – Enter 1234.
• Usage Password – Enter 4321 (resets usage statistics).