Specifications

1-30
Problem Probable Causes Corrective Action
M2007 displays
CHANGE FILTER
PAD.
Filter error has occurred, filter pad
clogged, 24 hour filter pad change prompt
has occurred or change filter pad was
ignored on a prior prompt.
Change the filter pad and ensure the filter
pan has been removed from the fryer for a
minimum of TWO minutes, then press 9 (1
YES) following any additional instruction
prompts displayed on the computer.
Do NOT
ignore CHANGE FILTER
PAD prompts.
M2007 display shows
chk pan.
A. Filter pan is not fully inserted into
fryer.
B. Missing filter pan magnet.
C. Defective filter pan switch.
A. Pull filter pan out and fully reinsert into
fryer.
B. Ensure the filter pan magnet is in place
and if missing replace.
C. If the filter pan magnet is fully against
the switch and computer continues to
display chk pan, switch is possibly
defective.
M2007 display shows
hot-hi-1.
Frypot temperature is more than 410ºF
(210ºC) or, in CE countries, 395ºF
(202ºC).
This in an indication of a malfunction in
the temperature control circuitry, including
a failure of the high-limit thermostat.
M2007 display shows
HI-LIMIT.
Computer in high-limit test mode.
This is displayed only during a test of the
high-limit circuit and indicates that the
high-limit has opened properly.
M2007 display shows
low temp.
Frypot temperature is between 180°F
(82°C) and 315°F (157°C).
This display is normal when the fryer is
first turned on while in the melt cycle
mode. To bypass the melt cycle press and
hold a #2 product button under the LCD
display until a chirp is heard. The alarm
will chirp and the computer displays EXIT
MELT alternating with YES NO. Press
the #1 YES button to exit melt. It may
appear for a short while if a large batch of
frozen product is added to the frypot. If
the display never goes out, the fryer is not
heating.
M2007 display shows
ERROR RM
SDCRD
Defective SD Card
R
eplace card with another card.
M2007 display shows
PROBE FAILURE.
Problem with the temperature measuring
circuitry including the probe.
This indicates a problem within the
temperature measuring circuitry. Check
resistance of probe, if faulty replace probe.
M2007 display shows
PROBE FAILURE
with alarm sounding.
Damaged computer wiring harness or
connector.
Swap the computer wiring harness with one
known to be good. If problem is corrected
replace the harness.
M2007 display shows
IGNITION
FAILURE.
Failed computer, failed interface board,
open high-limit thermostat.
Is displayed if the fryer loses its ability to
heat oil. It is also displayed when the oil
temperature is above 450°F (232°C) and
the high-limit thermostat has opened,
halting the heating of the oil.