Installation guide

The Programming
Assistance Button
(A.k.a. PAB.)
The PAB is located on the
side of the Module. This
push button mimics the
Hood-Pin switch in order to
avoid having to get out of
the vehicle and pressing the
Hood-Pin switch. The PAB
will work only when the
Hood is up.
How to Program the Transmitter.
1. FLASH the Hood Pin Switch.
Before the 20 seconds have passed, turn the Ignition Key to the IGNITION ON (RUN) position.
Turn the IGNITION to OFF.
2. Press and hold the LOCK button until the vehicle gives 5 flashes. The Module has
stored the Transmitter in its memory.
3. Close the Hood, to exit.
Table 1
The Module has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
programmed, the code of the first Transmitter will be erased from memory. To erase all
Transmitter codes from memory, you must perform a Module reset (See “Resetting the
Module” on page 16 ).
To program the Transmitter on a second vehicle (Multi-car Operation),
you must press the TRUNK button (of the secondary Transmitter you wish to
program) during step 2 of transmitter programming.
How to Enter Options Programming Mode
The module is equipped with four custom programming modes that allow the installer to custom-fit
the system outputs according to installation requirements. The programming options are designed
to facilitate interfacing with all vehicle types. (See section Table of Programming Options later in
this guide.). To enter the programming center, follow these procedures :
1. Flash the hood pin switch (see page 8)
– The parking lights will stay on for up to 20 seconds.
– Before the lights go out:
2. Press and hold the brake pedal and press one of the following buttons on the transmitter:
• LOCK to access mode 1;
• UNLOCK to access mode 2;
• TRUNK to access mode 3;
• START/STOP to access mode 4.
The parking lights will flash and the horn will honk once (if configured), twice three times or
four times to confirm entry into a mode.
3. Release the brake pedal.
4. To exit programming centre, simply close the hood.
Table 2
To get into the programming centre
Installation Guide P.9