Installation guide

Installation Guide P.17
The system will play back the most recent event first, then the second most-recent, and so
on. If there are no events at all to report, the Parking Lights will give one long flash.
Start Failure Codes via Parking Lights
1 x = No Start
3 x = Hardware Reset
4 x = Brakes
5 x = No Tach cut-off
6 x = Hood
7 x = Engine Running, no Ignition
detected, or Tach before Start
10 x = Alarm condition
Intrusion Codes
1 x = Power-up Reset: Battery disconnected
/ reconnected or dead…
2 x = Doors intrusion
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
Note: “x” stands for one flash of the Parking Lights
Intrusion Codes via LED light
If there has been an intrusion in the vehicle while it was locked and armed, the LED will
provide an intrusion code corresponding to the type of the intrusion which took place. The
LED intrusion codes are flashed in continuous loops. They are the same codes as those
provided during Events Playback:
1 x = Power-up Reset: Battery
disconnected / reconnected or
dead…
2 x = Doors intrusion
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
Chirps
Chirps Description
1
• LOCK and ARM the system.
• LOCK confirmation.
• Entering Mode 1 in Programming Options.
• Start attempt when the Engine is already running under remote control.
• Disarmed Notification
2
•
UNLOCK and disarm.
• Transmitter Programmed.
• Entering Mode 2 in Programming options.
3
•
LOCK and arm while a zone is left unprotected.
• Entering Mode 3 in Programming Options.
• Door zone left unprotected.
4
•
UNLOCK and disarm: an intrusion was detected.¸
• Entering Tach-learning Mode.
5
• Siren or Horn Chirp Timing adjustment
Constant up to 30
seconds
• Panic Mode causes the Horn/Siren to sound.
Constant up to
60 seconds
• Alarm condition generated by an intrusion, by triggering Panic Mode, or
when the Module is powered up.