Installation guide

Supplementary Information
Fifth Relay Output (2
nd
IGN or 2
nd
ACC or 2
nd
START)
This Remote Starter is equipped with a high-current programmable 5th relay onboard that can be
used to power a second Ignition, Accessory, or Start wire.
The Unit uses a series of jumpers; each set of jumper pins represents a function. In order to
activate any one of the three possible 2nd outputs, you must place the jumper (supplied) on one of
the three sets of pins and simply connect the 14 AWG wire to the second
IGN or ACC or START wire of
the vehicle.
Caution!
Do not use more than one of the three
sets of jumper pins simultaneously.
The relay output rating on this Unit is
25A max output. Defective OEM
solenoid switches can sometimes draw
up to 50 or 60A, causing the 30A fuse
to blow. Using a digital voltmeter, check
the Starter wire for amperage when
vehicle is cranking.
Ignition-Controlled Door Locks
• Ignition Lock disabled: turns OFF the Ignition Lock feature.
• Ignition Lock enabled: locks all Doors when the key is in the ON position and the user
presses the Brake Pedal. Similarly, when the Ignition key is turned to the OFF position,
the Doors will unlock.
• Ignition Lock Only: the system will only lock all Doors when the Ignition Key is turned
to the IGNITION ON (RUN) position and Brake Pedal is pressed.
• Ignition Unlock Only: the system will unlock all Doors when the Key is turned to the
OFF position, provided the Ignition Key was in the IGNITION ON (RUN) position and the
Brake Pedal was pressed at least once.
Table 7
Secure Lock
For vehicles where the OEM Alarm can be controlled the through the OEM LOCK and UNLOCK wires,
Secure Lock saves the installer from connecting the
ARM and DISARM wires and the LOCK and
UNLOCK wires to the OEM LOCK and UNLOCK wires.
Upon receiving a remote start signal the system will unlock the Doors (disarming the OEM Alarm);
1/2 sec after the remote start, the system will
LOCK the Doors.
Please note: most factory Alarm systems will not rearm while the Engine is running but will lock
the Doors.
4 seconds after the Module shuts off (i.e.: runtime expired or pressing the
STOP button), Secure
Lock will
LOCK (once more) all the Doors of the vehicle and REARM the OEM Alarm.
Smart Secure Lock operates as follows:
P.14 Installation Guide