Installation guide

P.12 Installation Guide
2. With the hood up (ground on the hood pin line), start the vehicle using the key.
3. Let the engine reach proper idle speed
The parking light output from the module is activated when the vehicle starts and it will
shut off once the tach signal is detected.
4. Press and hold the brake pedal until the parking light output from the module flashes 5 times.
5. Turn the Ignition OFF. At this point, the tach setting has been programmed.
Table 4
Multi-Speed Tach Programming
No manual adjustments are necessary. However, you should go through the Tach programming
procedure every time a new Unit is installed.
1. FLASH the hood pin switch.
2. Press and hold the Brake Pedal.
• Press the LOCK and UNLOCK buttons simultaneously.
• The parking lights will flash 4 times the horn/siren will sound 4 times (if programmed).
• Release the brake pedal.
3. Start the vehicle and let it to reach regular engine-idle speed.
4. Once the vehicle is idling properly, press and hold the brake pedal until the parking lights
flash five times, release the brake pedal: the tach signal is now programmed.
• The Horn/Siren will sound 1, 2 or 3 times depending on the Tach mode which has
been detected.
Table 5
Tach Adjustments
After having programmed the tach you might need to adjust it (increase or decrease the idle
speed). In order to do so, you will need to follow these steps:
1- Flash the hood pin (see page 8)
2- Enter the programming centre.
3- Press and hold the brake pedal
4- Press simultaneously the LOCK and UNLOCK buttons.
5- With the brake pedal still pressed,
a. Press UNLOCK to decrease the idle speed, or,
b. Press LOCK to increase the idle speed.
6- Once you have obtained the desired idle speed, press TRUNK to save the new settings. The
parking lights will flash five times. If the horn has been configured, you will hear one honk if the
last button pressed was LOCK, and, two honks if the last button pressed was UNLOCK.
7- Release the brake pedal and close the hood.
8- The adjustment is done.
Table 6
Testing
Before putting back the vehicle together, it is recommended to check that the system operates
properly. The following testing procedures should be used to verify proper installation and
operation of the system. Before testing, make sure that all connections are soldered and that the
unit is plugged in.
1. Remote-start the Engine and listen for Starter drag. If the Starter cranks for too
long, carry out another Tach learning procedure.
2. Test Hood Switch shutdown: with the vehicle running under the Remote Starter,
open the Hood; the vehicle should shut down. If it does not shut down, check the
Hood Pin-switch and its connector.