Installation guide

Installation Guide P.11
Option 2:
Level 1
(requires pressing the SHIFT button 1X) Æ Basic features
Level 2 (requires pressing the SHIFT button 2X) Æ Multi car operation
Level 3 (requires pressing the SHIFT button 3X) Æ Customized features
Option 3:
Level 1
(requires pressing the SHIFT button 1X) Æ Customized features
Level 2 (requires pressing the SHIFT button 2X) Æ Multi car operation
Level 3 (requires pressing the SHIFT button 3X) Æ Basic features
Option 4:
Level 1
(requires pressing the SHIFT button 1X) Æ Basic features
Level 2 (requires pressing the SHIFT button 2X) Æ Customized features
Level 3 (requires pressing the SHIFT button 3X) Æ Multi car operation
Example: If the multi-level features were set to option 3, the setup would be as follows:
x Level 1 Æ Customized feature
x Level 2 Æ Multi car operation
x Level 3 Æ Basic features
The “Basic features” are now programmed as level 3 and therefore:
x To access the aux.2 feature, the user needs to press on the SHIFT button three (3) times
followed by the LOCK button.
x To access the status request feature, the user needs to press on the SHIFT button three
(3) times followed by the TRUNK button.
x To access cold weather mode, the user needs to press on the SHIFT button three (3)
times followed by the START/STOP button.
Horn Honk / Siren Timing (Optional)
1. Make sure that Mode 3 Function 4 Option1 or Option 3 is activated.
2. FLASH the Hood Pin Switch
Before the 20 seconds have passed,
3. Press and hold the Brake Pedal.
• Press the START and UNLOCK buttons simultaneously on the Transmitter.
• The Horn/Siren will sound 5 times.
4. Release the Brake Pedal.
5. To change the timing:
a. To increase the Horn Honk/Siren by 3 ms, press the LOCK button.
b. To increase the Pulse by 10 ms, press the START
c. To decrease the Pulse by 3 ms, press the UNLOCK button.
d. To decrease the Pulse by 10 ms, press the TRUNK button.
6. To save the setting: press LOCK and UNLOCK. If 3 Honks/Chirps are heard the new value
has been saved.
For each timing change, the Horn/Siren will sound with the new setting, except
under the following circumstances:
• When the lower limit of 5 ms is reached, the Horn/Siren will sound for 1/4 second.
• When the upper limit of 200 ms is reached, the Horn/Siren will sound for
3/4 second.
A system reset will set the system back to the default: 30 ms
Close the Hood to cancel the changes.
Table 3
Auto Tach Programming Procedure
NOTE: If no tach has been programmed and the start button is pressed, there will be no start
attempt and the vehicle will give 5 flashes. If another tach programming is required, simply
repeat the auto tach programming procedures. The module stores the tach setting, being auto
tach or conventional tach, until the module is reset.
This process can be carried out instead of the conventional tach programming procedure.
1. Make sure all the connections are done properly and that the module has been powered-up.