Installation guide

ManualsBrandsAutostart ManualsAutomotiveAS-6320 FM

P.10 Installation Guide

Note: The unit will stay in the selected programming mode until the hood pin-switch or the brake

pedal is pressed again. Therefore take your time to make the proper selection. Pressing the

brake pedal will take you back to the programming centre, where you can select a different mode.

Once you access a particular programming mode, you will automatically start at function 1. Once

you select one of the options of function 1, you will automatically be taken to the next function.

To select one of the five options of any given function, press the corresponding button on the

transmitter:

• LOCK button .............................to access option 1

• UNLOCK button .........................to access option 2

• TRUNK button ...........................to access option 3

• START button ............................to access option 4

• SHIFT then LOCK buttons ...........to access option 5

Accessing options

In each function, once an option has been selected the parking lights will flash 1, 2, 3, 4 or 5 times

(depending on the selected option). Please note that the different functions within any particular

mode can only be accessed sequentially: the programming centre will move from function 1 to

function 2, then to function 3, and so on. Therefore, whenever you access a particular mode, be

prepared to re-configure all the functions of that mode in ascending order.

Multi-Level Features (default state)

Basic Features (press the SHIFT button 1X)

SHIFT ¾ LOCK:........................................................................aux 2

SHIFT ¾ START/STOP............................................................ cold weather

Multi-Car Operation (press the SHIFT button 2X)

SHIFT ¾ SHIFT ¾ LOCK:.................................2

car lock

SHIFT ¾ SHIFT ¾ UNLOCK:............................2

car unlock

SHIFT ¾ SHIFT ¾ START/STOP: .................... 2

car start/stop

SHIFT ¾ SHIFT ¾ TRUNK: .............................. 2

car trunk

Customized Features (press the SHIFT button 3X)

(May not be applicable for certain vehicles)

Your installer can add customized features such as turning on the radio, opening sliding

doors, etc.

SHIFT ¾ SHIFT ¾ SHIFT ¾............................. LOCK: customized feature 1

SHIFT ¾ SHIFT ¾ SHIFT ¾............................. UNLOCK: customized feature 2

SHIFT ¾ SHIFT ¾ SHIFT ¾............................. TRUNK: customized feature 3

SHIFT ¾ SHIFT ¾ SHIFT ¾............................. START/STOP: customized feature 4

By default, the multi-level features are programmed as follows:

Level 1 (Basic Features)

Level 2 (Multi car operation)

Level 3 (Customized Features)

To access a feature that is programmed as level 1, press the

SHIFT button once followed by the

desired function.

To access a feature that is programmed as level 2, press the SHIFT button twice followed by the

desired function.

To access a feature that is programmed as level 3, press the

SHIFT button three times followed

by the desired function.

Your installer can customize the system as to personalize these multi-level features in an order that

best suits you; your options are:

Option 1:

Level 1

(requires pressing the SHIFT button 1X) Æ Multi car operation

Level 2 (requires pressing the SHIFT button 2X) Æ Basic features

Level 3 (requires pressing the SHIFT button 3X) Æ Customized features