Product data

SCSI Bus Bridge Card Assembly
Attention: Before you remove the SCSI bus bridge card assembly, switch off the using
systems.
Removing the SCSI Bus Bridge Card Assembly
Step 1. Ensure that the using systems have been switched off.
Step 2. Remove the two modules that are directly on each side of the SCSI bus bridge
card assembly (see “Removing a Module” on page 75).
Step 3. Refer to Figure 33.
Step 4. Squeeze each of the four lugs on the cover 1, then remove the cover.
Step 5. Lift the handle 2 of the SCSI bridge card assembly fully.
2
1
Figure 33. Removing the SCSI Bridge Card Assembly Cover
Chapter 3. Removal and Replacement Procedures 85