Product data
Step 7. If the 2104 is powered on, use the SCSI Device Identification and Removal
service aid to set the slot to Insert (see “System Service Aids” in
“Appendix A. Additional Information for RISC Systems”). The Check light that
is at the back of the slot (on the backplane) comes on.
Step 8. Refer to Figure 31.
Step 9. Ensure that the handle 1 is fully open on the module that you are going to
install.
Step 10. With one hand giving support to the base of the module and the other hand
holding the handle, insert the module, and push it into the slot whose Check
light is on (see step 7). When the handle touches the front of the 2104, the
module stops. Note that the module is not yet fully home.
Figure 31. Installing a Disk Drive Module
82 2104 Service Guide