Product data

Step 2. (from step 1)
a. Reinstall a fan-and-power-supply assembly into position 1.
b. Connect a power cable to the fan-and-power-supply assembly.
c. Set the DC On/Standby switch of the fan-and-power-supply assembly to
On.
Note: Unless a procedure needs you to switch off the 2104, leave the
2104 switched on for the remainder of this MAP.
Does the 2104 emit smoke or a smell of burning?
NO Go to step 3 on page 54.
YES
a. In the sequence shown, exchange the following FRUs for new
FRUs:
1) The fan-and-power-supply assembly that you have just
reinstalled
2) The frame assembly (see “Frame Assembly” on page 106)
b. Go to step 3 on page 54.
Chapter 2. Problem Determination Procedures 53