Product data
Configuring a Disk Drive Module to the Using System
If you have just installed a new disk drive module, and want to change the hdisk
number, do the following:
1. Remove the new hdisk number by giving the command:
rmdev -l [hdisknumber] -d
where [hdisknumber] is the hdisk number that you want to remove (for example,
hdisk12).
2. Remove the definition of the original hdisk by giving the command:
rmdev -l [hdisknumber] -d
where [hdisknumber] is the hdisk number of the original disk drive module (for
example, hdisk7).
3. Run the cfgmgr command.
Configuring a 2104 to the Using System
Use the cfgmgr command to configure or reconfigure a 2104 to the using system.
Unconfiguring a 2104 from the Using System
To remove a 2104 from the using system, give the following command:
rmdev -l [enclosurenumber] -d
where [enclosurenumber] is the enclosure device that was generated by the cfgmgr
command (for example, [ses0], [ses1], [ses2]).
Appendix A. Additional Information for RISC Systems 139
|