Product data

The Certify service aid takes approximately 10 minutes to run.
SCSI Device Identification and Removal
To run this service aid:
1. Go to the using system, select Diagnostic Operating Instructions, and follow the
instructions to select the Function Selection menu.
2. Select Task Selection.
3. Select Identify and Remove Resource.
4. Select the device (enclosure or disk drive) from the displayed list.
5. Select the slot from the displayed list.
6. A menu is displayed. From this menu, you can choose to:
v Set a disk drive module to Identify. The Check light of the selected disk drive
module flashes so that you can physically identify that module. The Identify
function does not affect the operation of the disk drive module.
v Set a disk drive module to Remove. The Check light of the selected disk drive
module comes on and remains on continuously so that you can physically identify
the module that you are going to remove. The light goes off when the disk drive
module is removed. The Remove function does not affect the operation of the
disk drive module until that module is removed.
v Set a disk drive slot to Insert. The Check light at the back of the slot (on the
backplane) comes on and remains on continuously so that you can physically
identify the slot into which you are going to install a disk drive module.
v Set a disk drive module or slot to Normal. The Check light of the disk drive
module, or slot, goes off.
Appendix A. Additional Information for RISC Systems 135