Product data

2104 Model DU3
Note: For a translation of the following notice, see “Appendix D. Translated Safety
Notices” on page 167.
CAUTION:
v The stabilizer must be correctly attached to the bottom front of the rack to
prevent the rack from tipping forward while the units are being removed from
the rack. Do not pull out or install any unit if the stabilizer is not attached to
the rack.
v If the 2104 is installed in a Model T00 or T42 rack, you must also observe the
safety notices for those racks before you start to remove the frame assembly.
You can find the safety notices in the System Installation chapter of the 7014
Model T00 and T42 Rack Installation and Service Guide, SA33-0577, or at web
page:
http://www.rs6000.ibm.com/resource/hardware_docs/sa38-0577/a4aw9bas.html
Step 1. Refer to Figure 49
Step 2. Remove the two front mounting screws 1.
Figure 49. Removing the Front Mounting Screws
Chapter 3. Removal and Replacement Procedures 107