Instruction manual

3. While continuing to push the disk drive module into the slot, slowly close the handle
1 until it stops with a click. This action pushes the module fully home.
Attention: The fans might decrease in speed.
4. Verify that the disk drive module that you have just installed is aligned with the sides
of the 2104, and that there is no gap between this module and the modules that are
next to it.
Verify also that the front edge of this disk drive module aligns with the front edges of
the modules next to it.
If the disk drive module is not correctly aligned, remove it (see step 2 on page 39)
and reinstall it (steps 2 through 3 above).
Figure 22. Closing the Handle of a Disk Drive Module
Chapter 2. Adding Disk Drive Modules 31