User guide

P. 9 User Guide
5. Exit the vehicle and close the door.
6. Press and hold either:
a. LOCK to lock the doors and shut down the engine after 60 sec.;
b. UNLOCK to unlock the doors and shut down the engine after 60 sec.;
c. START/STOP to shut down the engine immediately, without affecting the doors
(This will by -pass turbo mode).
Valet Mode with the Valet Switch
When your vehicle is in valet mode, the remote starter functionalities are disabled. If the vehicle
needs to be serviced, or if you park it indoors, the valet mode will prevent the engine from being
remote-started accidentally.
To put the system into valet mode:
1. Turn the ignition key to the IGNITION ON (RUN) position.
2. Within 3 sec onds, press the valet button. The parking lights will flash three times and the L.E.D.
will turn itself on.
To take the system out of valet mode:
1. Turn the ignition key to the IGNITION ON (RUN) position.
2. Within 3 sec onds, press and release the valet button. The parking lights will flash twice and the
L.E.D. will turn itself off.
Note: Once valet mode is activated, the remote starter and alarm functions will be disabled.
Ignition Valet
This feature will allow you to remotely put your system into valet mode by using the ignition key
instead of the valet button as above. Ignition valet can be used without a valet button installed.
To put the system into valet mode:
• Insert the ignition key into the ignition switch; within 10 sec onds, turn the key 5 times
successively into the IGNITION ON / RUN and OFF positions.
• The parking lights will flash three times to indicate that the vehicle is now in valet mode and the
L.E.D. will turn itself on.
To take the system out of Valet Mode:
• Insert the igniti on key into the ignition switch; within 10 seconds, turn the key 5 times
successively into the IGNITION ON / RUN and OFF positions.
• The parking lights will flash twice to indicate that the vehicle is now in valet mode and the L.E.D.
will turn itself off.
Note: With the remote valet activated, the remote starter and alarm functions will be disabled.
Start Attempts Indicator (Valet Mode)
This reveals start attempts made while the vehicle was in valet mode. The parking lights will:
• Come ON, go OUT ; then
• Flash twice.
“Home Valet
TM
” Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote.
To take the system into home valet mode:
• Press the LOCK or UNLOCK button.
• Within 5 seconds, press the LOCK and START/STOP button simultaneously.
The transmitter will beep once and the home valet icon will start flashing. The icon will flash
until the vehicle exits home valet mode.