User guide

User Guide P. 8
Using the System
Arming and Disarming the System
To disarm the alarm and starter kill (if installed) and unlock the doors (if
installed):
1. Press and hold the UNLOCK button for approx imately 1 second.
There will be two chirps if the siren or horn is so configured.
2. The icon will appear, the parking lights will flash twice and the L.E.D. will go out to
confirm that the doors have been unlocked and that the starter kill (if installed) and the alarm
are disarmed.
In passive mode, the system will rearm automatically 30 seconds after unlocking unless the key is
meanwhile inserted in the ignition switch (see description of passive mode later in this guide).
To arm the alarm and starter kill (if installed) and lock the doors (if installed):
1. Press and hold the LOCK button for approx imately 1 second.
You will hear one chirp if the siren or horn is so configured.
2. The icon will appear, the parking lights will flash once and the L.E.D. will flash slowly to
confirm that the doors have been locked and that the starter kill feature (if installed) and the
alarm are armed.
Idle Mode
Convenience feature: Idle mode allows you to keep the engine running and the doors
locked while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no key in the
ignition switch) while the engine is running. For example, if you stop for a delivery or at a conveni-
ence store, lock your vehicle and leave it running for the length of a run cycle while you are away.
Idle mode can be activated through the same routine as that used for ready mode; at the last step,
the TRUNK button is pressed instead of the other buttons:
1. Ensure that all the doors are closed and that the shifter is in the neutral position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. push LOCK, UNLOCK or START/STOP on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press the TRUNK button until the system is armed (the doors will be locked if remote door lock is
installed).
If the pre-programmed run-time ex pires or if the user shuts down the engine by remote control, the
vehicle will get in ready mode.
Caution!!! Do not leave children or pets unattended in a vehicle standing in idle mode.
Turbo Mode
If turbo mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine and set the system to ready mode.
To activate turbo mode, follow all steps of the ready mode routine:
1. Ensure that all the doors are closed and that the shifter is in the neutral position.
2. With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
3. Within 20 sec. press LOCK, UNLOCK or START/STOP on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.