User guide

P. 7 User Guide
6. Press and hold either:
a. LOCK to lock the doors and shut down the engine;
b. UNLOCK to unlock the doors and shut down the engine;
c. START/STOP to shut down the engine without affecting the doors.
Remaining In Ready Mode
Once the vehicle is in ready mode you can start and stop the vehicle at wish. However, should any
of the following occur, the vehicle will exit ready mode – thus eliminating the remote start option
until ready mode is restored:
• Door opened;
• Hood opened;
• Brake pedal pressed;
• Parking brake disengaged;
• Ignition key turned to the IGNITION ON (RUN) position.
Should any of the above occur, ready mode will be cancelled.
Note: The unit will notify the user that it has exited ready mode by giving 3 slow flashes
(parking lights).
Remote-starting
Press the START/STOP button for approx. 1 second. The parking lights will come ON and the remote
control will play a melody to inform you that the system has received your signal. Approximately 5
seconds later, the engine will start the parking lights will remain on during the pre-programmed
run time of the engine. The remote control will play a second melody to confirm that the engine has
started. If the vehicle does not start at the first attempt, the system will shut down.
WARNING!
It may require as much as 10 seconds before receiving the second confirmation signal;
therefore, pressing any buttons before receiving that confirmation will abort the
confirmation process.
Vehicle Presets
Heater & Heated Seat
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the
next remote start. Settings for the blower motor (fan), front and rear, as well as heated seats (if
equipped) should not be left on HIGH. It is recommended to leave the settings on LOW or MEDIUM
instead.
Windshield Wipers & Radio & Headlights
Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to become
energized while running under remote start. When leaving the vehicle you must ensure that the
windshield wiper and headlight switches are OFF. Leaving the headlight switch ON on certain types
of vehicles could cause them to remain ON even after remote starter shut down, resulting in a dead
battery.
Driving Off
With the vehicle running under remote control, press the UNLOCK button to disarm and unlock the
doors. Enter the vehicle and do the following:
• Turn the ignition key to the IGNITION ON (RUN) position. (Do not turn the key to the CRANK
position while the engine is running. This would cause the starter motor to re-engage.)
• Press the brake pedal to disengage the remote starter unit.
You are now ready to drive off.