TWO -WAY MANUAL STARTER S Y S T E M TRANSMISSION W I T H F U L L REMOTE A L A R M AS-6070 TW-A User Guide A note concerning the battery inside the transmitter: Depending on your usage of the transmitter, the battery can last anywhere between 3 to 6 months. When the battery is low, the transmitter will produce two beeps in a repetitive cycle. At that point you should replace your battery with a new one. That is why we recommend that you keep a spare battery somewhere handy such as the glove compartment.
Table of Contents Table of Contents................................. 2 Introduction............................................ 2 Using the Remote Control................... 2 LCD Remote Functions ....................... 3 LCD Transmitter Operation (First Car Control)........................................... 3 Basic Vehicle Operation...................... 3 Transmitter Mode Selection................ 3 Time or Alarm Clock Adjustments ..... 4 Cold Weather Mode............................. 4 Home ValetTM....
The functions of the transmitter are as follows: LCD Remote Functions The transmitter offers several command-confirmation and timer features. This section explains some of the key functions available on the remote control. Next section gives a summary of the button combinations used to access the functions (see LCD remote operation tables).
ALARM CLOCK MODE ON/OFF Press once to switch the Alarm Clock ON Press twice to switch the Alarm Clock OFF Melody + Time or Alarm Clock Adjustments User Transmitter 1. Press and hold the FUNCTION button until a beep is heard 2. Upon hearing the beep, release the FUNCTION button, 3. Press and hold the FUNCTION button once more 4. Release the FUNCTION button when a beep is heard, 5. Press and hold the FUNCTION button once more until a beep is heard, 6. Release the FUNCTION button 7.
Home ValetTM FUNCTION BY PRESSING Step 1 : ICON or TO ENTER HOME + VALET ™ MODE Step 2: simultaneously within 5 seconds TO EXIT HOME VALET ™ MODE BUZZER 1 BEEP NONE NONE BY PRESSING ICON NONE INSTRUCTIONS / DESCRIPTION Press or press + ; within 5 seconds, The icon w ill be : displayed and there will be 1 beep. Insert the key in the ignition switch and turn it to the IGNITION ON / RUN position. The icon will disappear after pressing the LOCK or ULOCK button.
*Runtime Options (once the car has been remote started) FUNCTION BY PRESSING ICON ENGINE RUNTIME GAS DIESEL 4 minutes 9 minutes 15 minutes 20 minutes 25 minutes 30 minutes LCD Transmitter Operation (Second Car Control) Basic Vehicle Operation FUNCTION BUTTON PRESS LOCK ICON 1 Beep + UNLOCK 2 Beep + START + STOP BUZZER + None + DESCRIPTION Locks the doors and arms the Starter Kill (if installed) and the alarm.
6. Press and hold either: a. LOCK to lock the doors and shut down the engine; b. UNLOCK to unlock the doors and shut down the engine; c. START/STOP to shut down the engine without affecting the doors. Remaining In Ready Mode Once the vehicle is in ready mode you can start and stop the vehicle at wish.
Using the System Arming and Disarming the System To d i s a r m the alarm and starter kill (if installed) and unlock the doors (if installed): 1. Press and hold the UNLOCK button for approx imately 1 second. There will be two chirps if the siren or horn is so configured. 2. The icon will appear, the parking lights will flash twice and the L.E.D. will go out to confirm that the doors have been unlocked and that the starter kill (if installed) and the alarm are disarmed.
5. Exit the vehicle and close the door. 6. Press and hold either: a. LOCK to lock the doors and shut down the engine after 60 sec.; b. UNLOCK to unlock the doors and shut down the engine after 60 sec.; c. START/STOP to shut down the engine immediately, without affecting the doors (This will by -pass turbo mode). Valet Mode with the Valet Switch When your vehicle is in valet mode, the remote starter functionalities are disabled.
To take the system o u t o f home valet mode: • Turn the ignition key to the IGNITION ON (RUN) position. The system will warn you if someone attempts to start your vehicle while it stands in Home Valet Mode. The parking lights will: • Go ON then OFF ; then • Flash twice, pause; then • Flash twice again. Remote Valet Mode This feature will allow you to remotely put your system into valet mode by using the transmitter instead of the valet button as above.
To exit cold weather mode, do any one of the following actions: • Open the hood. • Start the engine by remote. • Turn the ignition key to the IGNITION ON (RUN) position. • Press the brake pedal. • Press and hold the START/STOP button for 3 seconds (the parking lights will flash once). When the system exits cold weather mode, the icon will disappear after pressing the ULOCK buttons. LOCK or Temporary chirp delete To temporarily disable the chirp confirmations of the siren upon arming and disarming (e.g.
not be able to start your vehicle with the key unless the system has been unlocked and disarmed first, or put into valet mode. Note: If the starter kill is installed, your vehicle will benefit from a protection against starter motor damage that could occur after remote-starting the engine should the user, by force of habit, turn the ignition key to the CRANK position.
Ignition-controlled Door Locks This is an added security feature. If your system was installed with the ignition-controlled door locks option, the doors will automatically be locked as soon as the ignition key is turned to the IGNITION ON (RUN) position while the brakes are pressed. When the key is turned to the OFF position, the doors will automatically be unlocked.
Troubleshooting Poor Transmitting Range Many factors may affect the operating range of the transmitter. Some of these are: • The condition of the battery in the transmitter. • The operating environment (for example: downtown radio-frequency noise, airports, cellular phone towers…) • Metal: any type of metal will affect operating range. This includes the metal in the car. • The shape of the vehicle can affect range as well; vans in general have an especially poor range.
Diagnostics – Parking Light Flash Table Flashes 1 2 3 4 5 6 8 10 1 – pause – 2 2 – pause – 2 ON solid ON 2 sec. ON 3 sec. ON 4 sec. ON 25 sec. Irregular Constant flashes up to 30 sec. Constant flashes up to 60 sec. P. 15 Description • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • Doors locked, alarm and starter kill armed. End of run time. TRUNK button pressed Start signal received by the system. Cold weather mode cancelled. Cannot start after maximum number of attempts is reached.
