Installation guide

Installation Guide P. 9
Remember:
Once the Parking Lights are ON (solid), you have up to 20 seconds to select a sub-
menu. If you do not select a sub-menu within 20 seconds, the System will exit
Programming Mode and you will have to flash the Hood Pin switch once again.
The Programming Assistance Button
(A.k.a. the PAB.) Mounted on the system,
this button can be used from within the ve-
hicle instead of the hood pin switch in the
engine compartment. This will spare the
installer the trouble of accessing the hood
pin switch in the engine compartment.
Caution
The hood pin switch must be installed and connec ted in order for the programming
assistance button to function. The button will work only when the hood is up.
Programming a Transmitter
Before Proceeding
The transmitter of the system is not delivered pre-programmed: it must be programmed after the
wiring of the system is completed. The system has the ability to retain up to 4 different transmitter
codes; if a fifth transmitter is programmed, the code of the first transmitter will be lost from memory.
To erase all transmitter codes from memory, you must perform a reset of the system (see
Resetting the System, later in this guide, for more details).
A Word of Caution about the Alarm
The alarm is triggered when the unit is powered up because the default state of the alarm is armed.
You will therefore need to shut off the alarm before you carry out the transmitter code programming
procedure. One way to shut off the alarm is to (1) set the system to valet mode and then
(2) immediately set the system out of valet mode. (See instructions below.)
Getting into valet mode
1. Turn the ignition key to the IGNITION ON (RUN) position.
2. Within 3 seconds, press and release the valet button (the parking lights will flash 3X and
the L.E.D. will come on and stay lit).
The system must exit valet mode before a transmitter programming procedure can be
carried out:
Getting out of valet mode
1. Turn the Ignition Key to the IGNITION ON (RUN) position.
2. Within 3 seconds, press and release the Valet Button (the parking lights will flash 2X
and the L.E.D. will go out)
(See section valet operation, in the user guide, for more details on the use of valet mode.)
As the system exits valet mode, you will have 30 seconds to carry out the transmitter programming
procedure before the alarm rearms.