Installation guide

P. 8 Installation Guide
Connect the glow-plug wire to the ignition wire only
after the tach programming has been completed:
connecting the glow-plug wire is one of the very last
steps in the installation process.
2-Pin Harness
Wire Colour Function Description
1
BLUE/
WHITE
(–) AUX 2
output
This 500
mA negative output can be programmed for one of
the following Options:
1. Constant while the LOCK and UNLOCK
buttons are
pressed simultaneously, + 1 sec. after the buttons ar
e
released.
2. Pressing LOCK and UNLOCK
simultaneously toggles the
output on and off with automatic toggle off
after 30
seconds.
2 YELLOW
(–) Parking
Light output
500 mA negative Parking Light output.
Flashing the Hood Pin Switch
Flashing the hood pin switc h is a procedure that brings the system into programming mode. Once
the system is in programming mode, the installer will have up to 20 seconds to select one of the
sub-menus. If the installer fails to select a sub-menu before the 20-second delay, the system will
exit programming mode and the installer will have to flash the hood pin switch once more.
Tip As long as the hood is up, you may use the programming assistance button instead
of the hood pin switch.
Here are the steps which the installer must follow in order to flash the Hood Pin switch:
The Installer … The Module …
1. Press and hold the hood pin switch for 4 seconds.
2. Release the hood pin switch.
The Parking Lights will turn ON.
3. While the parking lights are ON, press down the
hood pin switch once more.
4. Release the hood pin switch again.
Caution! If you press down and release the hood
pin switch too many times, you will enter diagnostic
mode rather than programming mode.
The Parking Lights will stay ON
for 20 seconds
5. You now have 20 seconds to select one of the sub-
menus.
Table 1: Flashing the Hood Pin switch
Once the system has entered programming mode, you will have a selection of many different sub-
menus, which will be described later in this guide:
a. Transmitter Programming
b. Programming Options
c. Honk/Horn Timing (if available)
d. Tach Programming