Installation guide

P. 22 Installation Guide
3
• LOCK and arm while a zone is left unprotected.
• Entering mode 3 in the programming centre.
• Door zone left unprotected.
4
• Unlock and disarm: an intrusion was detected (in warning chirps mode or full
chirps mode).
• Entering tach-programming mode.
5
• Siren or horn chirp timing adjustment
Constant up
to 30 seconds
• In horn mode: alarm condition generated by an intrusion, by panic mode or
when the system is powered up. the horn will sound for 30 sec.
Constant up
to 60 seconds
• In siren mode: alarm condition generated by an intrusion, by panic mode or
when the system is powered up. the siren will sound for 60 sec.
Diagnostics – Parking Light Flash Table
Flashes Description
1
• Doors locked, alarm and starter kill armed.
• End of run time.
• TRUNK button pressed
• Start signal received by the system.
• Cold weather mode cancelled.
• Cannot start after maximum number of attempts is reached.
2
• Doors unlocked, alarm and starter kill disarmed.
• Run time cancelled.
• Exit remote valet.
• Exit ignition valet
• Remote start attempt cancelled by remote.
3
• Entering cold weather mode.
• Entering remote valet.
• Entering ignition valet
4
• +12 V where detected on the brake line and cranking was cancelled.
• Entering tach-programming mode
5
• New transmitter programmed.
• Tach programmed.
6
• A remote start was attempted while a tach or a vacuum signal was detected
before cranking.
8
• Unit reset: occurs when the unit is reset to the factory defaults.
10
• The hood switch line went to ground during cranking or run time.
1 – pause – 2
• There was an attempt to start the vehicle while the system was in valet mode.
2 – pause – 2
• There was an attempt to start the vehicle while the system was in home valet
mode.
ON solid
• Cold weather mode: the brake pedal is being held down.
ON 2 sec.
• The hood is up and the hood switch line went to ground. this is step one of
the programming centre procedure.
ON 3 sec.
• First press of the START/STOP button under safe start.
ON 4 sec.
• Locking or unlocking a door (with door pulses configured to 4 sec.)
ON 25 sec.
• The hood pin-switch has been pressed twice: the unit went into step 1 of the
programming centre procedure, and no transmitter activity was detected for
20 seconds.
• Or the unit went into step 1 of the transmitter programming procedure and no
activity was detected for a few seconds. The unit has exited the transmitter
programming procedure.