Installation guide

Installation Guide P. 21
Events Logging
With this feature, the system will play back the last 4 start failure events codes and the last
intrusion code via the parking lights or L.E.D.
Events playback
Ensure that the Hood is up, that the vehicle is not in Valet Mode and that the Ignition is OFF.
• Hold down the Hood Pin-switch for 4 seconds.
• Release the Pin-switch. The Parking Lights will come on.
• While the Parking Lights are on, immediately push the Pin-switch 3 more times.
The Parking Lights and L.E.D. will flash the five events stored in memory.
Table 12: Events playback
The first four playback codes are start failure events, while the last playback code is an intrusion
code. There is a pause after each event code is played back. The system will play back the most
recent event first, then the second one, and so on. If there is no event at all to report, the parking
lights will give one long flash. To jump directly the intrusion code, press the brake pedal. Close the
hood to end playback.
Start Failure Codes through the Parking Lights
1 x = No Start
3 x = Hardware Reset
4 x = Brakes
5 x = No Tach Cut-off
6 x = Hood
7 x = Engine Running, no Ignition detected,
or Tach before Start
10x = Alarm condition
Note: “x” stands for one flash of the Parking Lights
Intrusion Codes
1 x = Power-up Reset: Battery
disconnected / reconnected or
dead…
2 x = Doors intrusion
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
Intrusion Codes through the LED Light
If there has been an intrusion in the vehicle while it was locked and armed, the LED will provide an
intrusion code matching the type of the intrusion which took place. The LED intrusion codes are
flashed in continuous loops, using the same codes as those provided during events playback:
1 x = Power-up Reset: Battery
disconnected / reconnected or
dead…
2 x = Doors intrusion
3 x = Shock Sense
4 x = Hood
5 x = Panic
6 x = Ignition
Diagnostics – Chirps Table
Chirps Description
1
• Doors locked, alarm and starter kill armed.
• Lock confirmation.
• Entering mode 1 in the programming centre.
• Disarmed notification
2
• Doors unlocked, alarm and starter kill disarmed.
• Transmitter programmed.
• Entering mode 2 in the programming centre.