Installation guide

P. 20 Installation Guide
• Release the Pin-switch. The Parking Lights will come on.
• While the Parking Lights are on, immediately push and release the Pin-switch
again. The Parking Lights will stay on for up to 20 seconds.
2. Press and hold the Brake Pedal, then simultaneously press the UNLOCK and
START/STOP buttons on the Transmitter – the Siren or Horn will chirp 5 times.
3. Release the Brake Pedal.
4. To change the timing:
a. To increase the Siren or Horn pulse by 3 ms, press the LOCK button.
b. To decrease the pulse by 3 ms, press the UNLOCK button.
c. To increase the pulse by 10 ms, press the START/STOP button.
d. To decrease the pulse by 10 ms, press the TRUNK button.
5. To save the new settings: press LOCK and UNLOCK. If 3 chirps are returned the new
settings have been saved.
Table 9: Adjusting Chirp Duration
Otherwise close the Hood to cancel the changes.
Note Select Siren or Horn in the Programming Options. The Siren and the Horn each have their
own settings. Changing the settings of one of them will not affect the settings of the other.
For each timing change, the Siren or Horn will chirp with the new settings, except in the
following cases:
• When the lower limit of 5 ms is reached, there will be a 1/4-sec. chirp.
• When the upper limit of 200 ms is reached, there will be a 3/4-sec. chirp.
A system reset will set the System back to the default values: 30 ms for the Horn and 120 ms for
the Siren.
Resetting the System
The system is equipped with a reset function that allows the installer to erase all transmitter codes
from memory and return all the programming options to the factory default values. Resetting the
system is not a required process. Most of the time, you can avoid resetting by fixing the issue
directly at the root of the cause.
1. Flash the hood pin switch (see Table 1)
– Once inside programming mode, you have 13 seconds to complete the next step.
2. Press and release the break pedal 6 ti mes (within 13 seconds from entering
programming mode).
3. The parking lights will flash 8 times to confirm resetting.
Table 10: Resetting without a Valet Button
On some vehicles (such as BMW and certain Volkswagen vehicles), resetting will not work if the
Brake Pedal is pressed while the Ignition Key is not in the IGNITION ON (RUN) position: you will need
therefore to hot-wire the Brake Pedal by manually jumping 12 V with a fused test lead at the Brake
Pedal switch.
1. Flash the hood pin switch (see Table 1)
– Once inside programming mode, you have 13 seconds to complete the next step.
2. Press and release the valet button 6 times or more until the parking lights start to
flash.
3. The parking lights will flash 8 times to confirm resetting.
Table 11: Resetting with the Valet Button