Installation guide

P. 14 Installation Guide
q Make sure the System properly enters and exits Ready Mode:
Setting the system to Ready Mode
1. Ensure that all the Doors are closed and that the Gear Shift Lever is in the NEUTRAL
position.
2. With the Engine already running, apply the Parking Brake and release the Brake
Pedal.
Make sure to release the Brake Pedal.
3. Within 20 sec. push LOCK, or UNLOCK.
The Parking Lights will flash 3 times quickly and remain lit.
4. Remove the key: the Engine will go on running.
5. Exit the vehicle and close the Door.
6. Press and hold either:
a. LOCK to lock the doors arm the alarm and shut down the engine or enter turbo
mode ;
b. UNLOCK to unlock the Doors and shut down the Engine or enter Turbo Mode ;
c. START/STOP to shut down the Engine without affecting the Doors.
Table 7: entering Ready Mode
Remaining in ready Mode
Once the vehicle is in Ready Mode, you can start and stop the vehicle at wish.
However, should any one of the following occur, the vehicle will exit Ready Mode, thus
disabling remote start capabilities until Ready Mode is restored:
• Door opened,
• Hood opened,
• Brake pedal pressed,
• Parking Brake disengaged,
• Ignition Key turned to the IGNITION ON (IGNITION ON / RUN) position.
Should any of the above occur, Ready Mode will be cancelled.
Table 8: remaining in Ready Mode
q Remote-start the Engine and listen for Starter drag. If the Starter cranks for too long,
carry out another Tach Programming procedure.
q Hood Switch shutdown. with the vehicle running under the System, open the Hood;
the vehicle should shut down. If it does not shut down, check the Hood Pin-switch and
its connector.
q Brake shutdown circuit. With the vehicle running under the System, press and release
the Brake Pedal. The Engine should shut down immediately. If the Engine continues to
run, check the Brake Switch connection.
q Parking Brake shutdown circuit. With the vehicle running under the System,
disengage the Parking Brake. The Engine should shut down immediately. If the Engine
continues to run, check the Parking Brake Switch connection.
q Door Pin shutdown circuit. Make sure the System exits Ready Mode when each
Door is opened while the vehicle is running under a Remote Start. (Test each door.)
q OEM Alarm Control. Make sure the Module is able to arm and disarm the OEM Alarm
(if applicable).