Installation guide

P. 10 Installation Guide
Transmitter Programming Procedure
1. Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay ON for up to 20 seconds.
– Before the lights go out, turn the Ignition Key to the IGNITION ON (RUN) position.
– Immediately turn the Ignition Key back to the OFF position.
Press and hold the LOCK button and keep it down until the Parking Lights flash
5 times quickly. The siren will also chirp twice.
– The System has stored the code of the Transmitter into memory.
2. To exit: close the Hood.
Table 2: Programming a Transmitter
Entering Programming Options Mode
The system is equipped with three custom programming modes that allow the installer to custom-fit
the system outputs according to installation requirements. The programming options are designed
to facilitate interfacing with all vehicle types. (See section table of programming options later in
this guide.)
1. Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay ON for up to 20 seconds.
– Before the lights go out:
2. Press and hold the Brake Pedal,
– And press one of the following buttons on the Transmitter:
• LOCK ................to access Mode 1;
• UNLOCK.............to access Mode 2;
• TRUNK...............to access Mode 3.
The Parking Lights will flash and the Siren will chirp once, twice or three times to
confirm entry into a Mode.
3. Release the Brake Pedal.
Table 3: Accessing modes
Note
The unit will stay in the selected programming mode until the hood pin-switch or the
brake pedal is pressed again. Therefore take your time to make the proper
selection. Pressing the brake pedal will take you back to the programming centre,
where you can select a different mode.
Once you access a particular programming mode, you will automatically start at function 1. Once
you select one of the options of function 1, you will automati cally be taken to the next function. To
select one of the four options of any given function, press the corresponding button on the
transmitter:
• LOCK button ......................to access Option 1
• UNLOCK button ..................to access Option 2
• TRUNK button ....................to access Option 3
• START/STOP button .............to access Option 4
Table 4: Accessing options
In each function, once an option has been selected the parking lights will flash 1, 2, 3 or 4 times
(depending on the selected option).
Please note that the different functions within any particular mode can only be accessed
sequentially: the programming centre will move from function 1 to function 2, then to function 3,