Specifications

3. The number of saved generations of the unit with wait conditions, the unit whose end is being waited for, or
both is not sufficient to save the execution results from one day of operation.
Add an execution schedule that satisfies the waiting rule to the unit whose end is being waited for indicated in
the message. Alternatively, in the case of 3. above, the system might have been unable to obtain generation
information because generations were being deleted. Check whether the execution ID of the unit whose end is
being waited for appears in the Wait Conditions Statuses window of JP1/AJS3 - View or in the -xw option of
the ajsshow command. If the execution ID appears, the unit can be waited for and the problem is resolved.
You can prevent this error message from appearing by ensuring that the number of saved generations allows the
system to save one day's worth of execution results for the unit with wait conditions and the unit whose end is
being waited for.
If you cannot take this approach, perform a temporary change operation to disable waiting for the unit to be
waited for indicated in the message.
For this cause, asterisks (***) appear as the execution ID of the unit in the message whose end is being waited
for.
Cause number: 3
The wait condition (wait method OR) was not satisfied because the unit with wait conditions indicated in the
message cannot finish waiting for all units whose ends are being waited for.
The probable reasons are as follows. Check the statuses of all the units whose ends are being waited for, and
take the appropriate action.
1. A unit whose end is being waited for terminated in a status that does not allow waiting to finish, waiting
cannot finish for a jobnet with start conditions and whose end is being waited for, or a unit is suspended.
Take the action described for cause number 1.
2. The unit whose end is being waited for is not registered for execution.
Take the action described for cause number 1.
3. There are no applicable generations of the unit whose end is being waited for, and the system is configured
not to execute the unit in these circumstances.
Take the action described for cause number 2.
For cause number 3, asterisks (***) appear as the full unit name and execution ID of the unit in the message
whose end is being waited for.
KAVS4973-I
A job (name: unit-full-name:execution-ID) is now able to wait for the end of a unit (name: name-of-unit-whose-
end-is-being-waited-for:execution-ID).
The job is now able to wait for the unit whose end is being waited for indicated in the message. The execution ID of
the job that can now wait for the unit is output if yes is specified for the LOGINFOALL environment setting parameter.
If the wait method of the wait condition is OR, this message is only output for the first unit whose end is being waited
for that transitions to a status that allows waiting.
(S)
Continues processing.
2. Messages
Job Management Partner 1/Automatic Job Management System 3 Messages 1
477