Specifications

• The specified unit whose end is being waited for was deleted from the wait condition definition while the command
was executing
• No unit names match the regular expression
(S)
Cancels command execution. If you specify multiple units (including by regular expression), the system continues
processing from the next unit.
(O)
Check the unit whose end is being waited for and then re-execute the command.
KAVS4661-E
This option (option) cannot be used because the preceding unit wait function is not enabled.
The chosen option cannot be used because JP1/AJS is not set up to use wait conditions.
(S)
Cancels command execution. If you specify multiple units (including by regular expression), the system continues
processing from the next unit.
(O)
Set up JP1/AJS3 to use wait conditions by following the instructions in 6.1.7 Settings for using wait conditions in
the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1 (for Windows) or
15.1.7 Settings for using wait conditions in the Job Management Partner 1/Automatic Job Management System 3
Configuration Guide 1 (for UNIX).
KAVS4662-E
Wait conditions is not defined for the unit (unit-name). : maintenance-information
Wait conditions are not defined for the unit indicated in unit-name.
(S)
Cancels command execution. If you specify multiple units (including by regular expression), the system continues
processing from the next unit.
(O)
Define wait conditions and then re-execute the command.
KAVS4670-I
Temporary change information does not exist in unit (
unit-name).
Temporary change information could not be output. The probable causes are as follows:
• No temporary change information exists for the target unit
• No temporary change information exists for the target unit after the specified start date
2. Messages
Job Management Partner 1/Automatic Job Management System 3 Messages 1
442