Installation guide

Supplementary Information
Fifth Relay Output (2
nd
IGN, ACC or CRANK)
Remote Car Starters of this series are
equipped with an on-board high-current
programmable 5
th
Relay that can be used
to power a second Ignition, Accessory or
Crank wire.
The Unit uses 3 sets of pins; each set
corresponds to a specific function of the
output. In order to activate one of the three
possible functions, you must place the
Jumper (supplied) on one of the three
sets of pins and connect the 14 AWG wire
to the second
IGN. / ACC. / CRANK wire of the
vehicle.
Caution!
Only one set of pins can be used at one time. Using more than one Jumper may
result in serious damage to the vehicle.
The relay output rating on this unit is 25 A at most. Defective OEM solenoid switches
can sometimes draw up to 50 or 60 A, causing the 30 A Fuse to blow. Always verify
your circuit with an appropriate measuring device.
Ignition-controlled Door Locks
(ENABLED by default.) This feature will LOCK all the Doors of the vehicle when the Brake
Pedal is pressed while the Ignition Key is in the
IGNITION ON (RUN) position. The unit will
UNLOCK all Doors when the Ignition Key is turned back to the OFF position.
If Ignition Lock Only is selected, the system will only
LOCK all Doors when the Brake Pedal
is pressed while the Ignition Key is in the
IGNITION ON (RUN) position.
If option Ignition Unlock Only is selected, the system will
UNLOCK all Doors when the key is
turned to the
OFF position (provided that the Ignition key was in the IGNITION ON (RUN) position
and that the Brake Pedal was pressed at least once).
Secure Lock
(OFF by default.) This feature allows the Remote Car Starter to control certain OEM factory
Alarm systems without requiring the use of other wires for disarming the OEM Alarm.
(Namely, this feature is designed for OEM systems which use the factory Lock wire to arm
the Alarm and the Unlock wire to disarm it.)
Standard Secure Lock
If this Option is selected, upon receiving a remote START signal, Secure Lock will UNLOCK the
Doors (disarming the factory Alarm); 1/2 sec. after remote start Secure Lock will re-lock the
Doors. 4 seconds after shutdown, Secure Lock will re-lock all Doors (arming the system
once again). Please note that most OEM systems will not rearm the Alarm while the Engine
is running, but will still lock the Doors.
P. 16 Installation Guide AS-2510 TW