Owner`s manual

4. If you wish to stop the cranking of the engine prior to
the engine starting, remove your foot from the brake
pedal and press the button again.
NOTE: Normal starting of either a cold or a warm
engine is obtained without pumping or pressing the
accelerator pedal.
NOTE: Under cold weather conditions, the engine may
not immediately crank if the ⬙Wait To Start⬙ telltale is
illuminated. This is normal operation. For vehicles
equipped with Keyless Enter-N-Go™, the vehicle will
automatically crank when the ⬙Wait To Start⬙ time has
elapsed. See the section ⬙Starting Procedure Engine Mani-
fold Air Temperature 0°F to 66°F (18° C to 19°C)⬙ for more
information.
To Turn Off The Engine Using ENGINE START/STOP
Button
1. Place the shift lever/shift selector in PARK, then press
and release the ENGINE START/STOP button.
2. The ignition switch will return to the OFF position.
3. If the shift lever/shift selector is not in PARK, the
ENGINE START/STOP button must be held for two
seconds and vehicle speed must be above 5 mph
(8 km/h) before the engine will shut off. The ignition
switch position will remain in the ACC position until
the shift lever/shift selector is in PARK and the button
is pressed twice to the OFF position. If the shift
lever/shift selector is not in PARK and the ENGINE
START/STOP button is pressed once, the EVIC (if
equipped) will display a “Vehicle Not In Park” mes-
sage and the engine will remain running. Never leave
a vehicle out of the PARK position, or it could roll.
158 STARTING AND OPERATING