User guide

AS-2360TW User Guide P. 7
x
x
x
x
x
x
By default, the multi-level features are programmed as follows:
Level 1 (Basic Features)
Level 2 (Multi car operation)
Level 3 (Customized Features)
To access a feature that is programmed as level 1, press the
SHIFT button once followed by the
desired function.
To access a feature that is programmed as level 2, press the
SHIFT button twice followed by the
desired function.
To access a feature that is programmed as level 3, press the
SHIFT button three times followed
by the desired function.
Your installer can customize the system as to personalize these multi-level features in an order that
best suits you. Your options are:
Option 1:
Level 1
(requires pressing the SHIFT button 1X) Æ Multi car operation
Level 2
(requires pressing the SHIFT button 2X) Æ Basic features
Level 3 (requires pressing the SHIFT button 3X) Æ Customized features
Option 2:
Level 1
(requires pressing the SHIFT button 1X) Æ Basic features
Level 2 (requires pressing the SHIFT button 2X) Æ Multi car operation
Level 3 (requires pressing the SHIFT button 3X) Æ Customized features
Option 3:
Level 1
(requires pressing the SHIFT button 1X) Æ Customized features
Level 2
(requires pressing the SHIFT button 2X) Æ Multi car operation
Level 3 (requires pressing the SHIFT button 3X) Æ Basic features
Option 4:
Level 1
(requires pressing the SHIFT button 1X) Æ Basic features
Level 2
(requires pressing the SHIFT button 2X) Æ Customized features
Level 3 (requires pressing the SHIFT button 3X) Æ Multi car operation
Example: If the multi-level features were set to option 3, the setup would be as follows:
x Level 1 Æ Customized feature
x Level 2 Æ Multi car operation
x Level 3 Æ Basic features
The “Basic features” are now programmed as level 3 and therefore:
x To access the aux.2 feature, the user needs to press on the SHIFT button three (3) times
followed by the LOCK button.
x To access the status request feature, the user needs to press on the SHIFT button
three (3) times followed by the TRUNK button.
x To access cold weather mode, the user needs to press on the SHIFT button three (3)
times followed by the START/STOP button.
Remote-Starting Your Vehicle
Setting Your Vehicle into Ready Mode
This product is designed for vehicles with a manual transmission only. In order to start the vehicle
by remote, the unit must first be set to Ready Mode. If the unit is not set to Ready Mode, it cannot
remote-start the vehicle.
Once the system is set to Ready Mode, the vehicle can be remote-started and stopped at wish.
The system will exit Ready Mode if a door or the hood is opened, if the brake pedal is pressed, if
the parking brake is disengaged or if the ignition key is turned to the
IGNITION ON (RUN) position.