Installation guide

AS-2360TW Installation Guide P. 9
9 PURPLE
(–) External
Trigger output
The external trigger wire can be used for remote-
startin
g
the vehicle with an external device. When
the vehicle is runnin
g
, tri
gg
erin
g
this input will
activate idle mode. The external tri
gg
er wire can also
be used to operate as a ne
g
ative tri
gg
er with the
trunk pin-switch, the key sense wire or the door pin-
switch:
Option 1 Connects to ne
g
ative trunk pin. When this
wire is programmed for trunk pin, pressing TRUNK will
activate a 1-second disarm output. If ground (-) is
detected on the trunk pin
(
the trunk has been
opened), an arm pulse will be sent 5 seconds after
the trunk is closes. An arm pulse will be sent 4
seconds after the TRUNK button is pressed if the trunk
pin state is unchanged (The trunk was unopened).
A
disarm pulse is sent onl
y
if the s
y
stem was
previousl
y
locked and armed. If secure lock is
enabled, unlock pulse(s) will be sent with the disarm
pulse, a lock pulse and a rearm pulse will be sent
when the trunk is closed or if the trunk was left
closed.
Option 2
(
Default: en
g
ine start/stop
)
: The first
ground (-
)
pulse on this input will start the en
g
ine, the
second ground (-
)
pulse on this input will stop the
engine.
Option 3 (Key Sense (-
)
Input
)
: Connects to OEM
key sense wire. When the key is detected in the
ignition switch (ground (-
)
si
g
nal on the OEM ke
y
sense wire) the starter kill will not arm even when it is
set to passive mode. If secure lock is pro
g
rammed,
lock and arm will not be activated while the ke
y
sense input is active (“active” meaning there is a ke
y
in the ignition barrel).
Option 4 (Smart ignition re-lock
)
: Connects to the
ne
g
ative door tri
gg
er input. When the i
g
nition lock
option or the lock onl
y
option is enabled, after the
brake pedal is pressed and after a door has been
opened and closed, the doors will re-lock.