Installation guide
P. 6 Installation Guide AS-2360TW
This wire will power the heater blower motor.
Usuall
y
connected to the accessories wire of the
vehicle. The source wire must have power with the
ignition key in the IGNITION ON (RUN) position only (no
power in the CRANK position).
E ORANGE
(+) Accessori
es output (30
A)
Warning: at the i
g
nition switch of certain vehicles,
there ma
y
be more than one i
g
nition wire for powerin
g
the heater blower motor. Use the 5
th
rela
y
(
Pin F
)
and
extra rela
y
s to power up an
y
extra i
g
nition wires if
necessary. Do not
j
ump wires at the i
g
nition
switch: this would compromise the OEM electrical
system.
This high-current output can be used to power a
second i
g
nition, accessories or crank wire. See
jumper setting on page 23, for correct output.
F GREEN
(+) Fifth
Relay output
(30 A)
Please note: additional i
g
nition, accessories, or
starter wires must use external relays. Do not
j
ump
wires at the i
g
nition switch: this would compromise
the OEM electrical system.
5-Pin Secondary Harness
Wire Colour Function Description
1 BLACK
(–)
Chassis
ground input
This wire must be connected to bare, unpainted metal
(the chassis or the true body ground). It is preferable
to use a factory ground bolt rather than a self-tappin
g
screw. Screws tend to
g
et loose or rusted over
time and can cause erratic problems.
This wire will allow the module to sense whether the
engine is running. The wire requires at least 1.8 V
(AC) and 1.6 Hz or faster when the en
g
ine runs at idle
speed. Common references for the tach wire are: the
ne
g
ative side of the i
g
nition coil, the camshaft sensor,
the crankshaft sensor or the en
g
ine control module
(ECM).
2 PURPLE
(A.C.)
Tachometer
input
Note: if the tach si
g
nal is too low, the module will
“over-crank”. Conversel
y
, if the tach si
g
nal is too hi
g
h,
the module will “under-crank”.
3 GREY
(–) Hood
switch input
Connect this wire to the installed hood pin switch
supplied. This input will disable or shut down the
remote starter when the hood is up.
4 ORANGE
(+) Brake
Switch input
This wire must be connected to the brake li
g
ht wire of
the vehicle. This wire must have +12 V onl
y
when the
brake pedal is down. This input will shut down the
remote starter if the brake pedal is pressed.