Installation guide

AS-2360TW Installation Guide P. 19
Example: If the multi-level features were set to option 3, the setup would be as follows:
x Level 1 Æ Customized feature
x Level 2 Æ Multi car operation
x Level 3 Æ Basic features
The “Basic features” are now programmed as level 3 and therefore:
x To access the aux.2 feature, the user needs to press on the SHIFT button three (3) times
followed by the LOCK button.
x To access the status request feature, the user needs to press on the SHIFT button three
(3) times followed by the TRUNK button.
x To access cold weather mode, the user needs to press on the SHIFT button three (3)
times followed by the START/STOP button.
Table 5
Horn Honk Timing
Follow these steps to program Horn Confirmation:
1. Ensure that the Hood is up and that the Ignition is OFF.
• Hold the Hood Pin-switch down for 4 seconds.
• Release the Pin-switch. The Parking Lights will come on.
• While the Parking Lights are on, immediately push and release the
Pin-switch again. The Parking Lights will stay on for up to 20 seconds.
2. Press and hold the Brake Pedal, then simultaneously press the UNLOCK and START
buttons on the Transmitter – the Horn will honk 5 times.
3. Release the Brake Pedal.
4. To change the timing:
a. To increase the Horn pulse by 3 ms, press the LOCK button.
b. To decrease the pulse by 3 ms, press the UNLOCK button.
c. To increase the pulse by 10 ms, press the START/STOP button.
d. To decrease the pulse by 10 ms, press the TRUNK button.
5. To save the new settings: press LOCK and UNLOCK. If 3 honks are returned the new
settings have been saved.
Table 6
Adjusting Honk Duration
Otherwise close the Hood to cancel the changes.
For each timing change, the Horn will honk with the new settings, except in the
following cases:
• When the lower limit of 5 ms is reached, there will be a 1/4-sec. honk.
• When the upper limit of 200 ms is reached, there will be a 3/4-sec. honk.
A system reset will set the Remote Car Starter back to the default values: 30 ms.
Tach Programming
About Tach Programming
If you press the START button before carrying out a Tach Programming procedure, the
Remote Car Starter will make no attempt to start the Engine and the Parking Lights will
give 5 flashes.