Installation guide

P. 14 Installation Guide AS-2360TW
Programming a Transmitter
Before you Proceed
The Transmitter of the Remote Car Starter is not delivered pre-programmed: it must be
programmed after the wiring of the Remote Car Starter is completed. The Remote Car
Starter has the ability to retain up to 4 different Transmitter codes; if a fifth Transmitter is
code-programmed, the code of the first Transmitter will be lost from memory. To erase
all Transmitter codes from memory, you must perform a reset of the Remote Car
Starter (see Resetting the Remote Car Starter, later in this Guide, for more details).
The Transmitter Programming Procedure
1. Flash the Hood Pin switch (see Table 1)
– The Parking Lights will stay ON for up to 20 seconds.
– Before the lights go out, turn the Ignition Key to the IGNITION ON (RUN) position.
– Immediately turn the Ignition Key back to the OFF position.
2. Press and hold the LOCK button and keep it down until the Parking Lights flash
5 times quickly.
– The Remote Car Starter has stored the code of the Transmitter into memory.
3. To exit: close the Hood.
Table 1
To program a Transmitter on the second vehicle for Multi-car Operation, you must
press the TRUNK button (instead of LOCK or UNLOCK) in step 3 of the Transmitter code-
learning procedure:
Entering Programming Options Mode
The module is equipped with four custom programming modes that allow the installer to
custom-fit the system outputs according to installation requirements. The programming
options are designed to facilitate interfacing with all vehicle types. (See section Table of
Programming Options later in this guide.)
To enter the programming center, follow either procedure (Table 2 or Table 3); please
note that the second procedure requires the use of the plug-in valet (not included):
1. Flash the hood pin switch (see page 12)
– The parking lights will stay ON for up to 20 seconds.
– Before the lights go out:
2. Press and hold the brake pedal,
– And press one of the following buttons on the transmitter:
• LOCK to access mode 1;
• UNLOCK to access mode 2;
• TRUNK to access mode 3;
• START/STOP to access mode 4.
The parking lights will flash and the horn will honk once (if configured), twice three times or
four times to confirm entry into a mode.
3. Release the brake pedal.
4. To exit programming centre, simply close the hood.
Table 2