User manual

Publication 1734-UM009B-EN-P - July 2003

1-2 Installing the ASCII Module

1. Position the mounting base/wiring base assembly vertically

above the installed units (adapter, power supply or existing

module).

2. Slide the mounting base down allowing the interlocking side

pieces to engage the adjacent module or adapter.

3. Press firmly to seat the mounting base on the DIN rail. The

mounting base will snap into place.

4. To remove the mounting base from the DIN rail, remove any

installed module (and any module immediately to the right), and

use a small bladed screwdriver to rotate the DIN rail locking

screw to a vertical position. This releases the locking

mechanism. Then lift straight up to remove the mounting base.

5. Repeat this procedure for the next mounting base assembly.

Module

Status

Network

Status

1734

232ASC

Mounting Base

Mechanical Keying

(orange)

Module Wiring Diagram

Module Locking Mechanism

Insertable I/O Module

RTB Removing Handle

Removable Terminal Block (RTB)

DIN Rail Locking Screw

(orange)

Slide-in Writable Label

Interlocking Side Pieces