User guide

P. 8 User Guide
2. The parking lights will flash once and the LED will flash slowly to confirm that the doors
have been locked and that the Starter Kill feature is enabled (if it was installed).
To UNLOCK your doors and DISARM the Starter Kill:
1. Press and hold the UNLOCK button for approximately 1 sec.
2. The parking lights will flash twice and the LED will go out to confirm that the doors have
been unlocked and that the Starter Kill feature is disarmed if it was installed.
Note: If installed and configured in Passive Mode at installation, the Starter Kill feature will
rearm automatically 60 seconds after the doors are unlocked. For that reason, you may
have to unlock your doors a second time if some time elapses before you actually start
the engine.
Priority Door Access
If the remote door locks option is installed on your vehicle, this safety feature allows you to
unlock solely the driver’s door with a single press of the
UNLOCK button on the transmitter;
upon a second press of the
UNLOCK button, all the other doors will unlock.
Ignition-controlled Door Locks Option
This is an added security feature. If your system was installed with the Ignition-controlled
Door Locks option, the doors will automatically be locked as soon as the user presses the
brakes while the ignition key is in the
IGNITION ON (RUN) position.
When the key is turned to the Ignition OFF position, the doors will automatically be unlocked.
(Only available if remote Door Lock Option is installed)
Secure Lock Option
Before it can remote start your vehicle, the module must first disarm the factory security
system.
The Secure Lock feature may be required on certain vehicle models with factory security
systems that automatically unlock the doors when the security system is disarmed.
To keep your vehicle protected when the factory security system is disarmed for a remote
start, Secure Lock will relock your doors as soon as the vehicle has started.
Once the engine run cycle ends, Secure Lock will rearm your factory security system.
Remote Trunk Release Option
If your system was installed with the Remote Trunk Release, you can open your trunk by
pressing the TRUNK button on the remote transmitter. Vehicles must have an electric TRUNK
switch or a remote TRUNK button on the vehicle’s OEM Transmitter for this option to be
compatible with the Module.
Starter Kill / Anti-Grind
This added security feature will immobilize your vehicle when the system is armed (LOCKED).
If your Module was installed with the Starter Kill option, you will not be able to start your
vehicle with the key unless the system has been disarmed first (
UNLOCKED).
The Starter Kill option can be programmed to be
ACTIVE (will not arm automatically) or PASSIVE
(will arm automatically). In
PASSIVE Mode, your installer can program it to arm automatically in
1 or 3 minutes.
Once the vehicle has been remote started, the Anti-Grind feature prevents the starter motor
from re-engaging when the ignition key is accidentally turned to the
CRANK position.
Note: Automobile insurance companies sometimes offer a rebate for vehicles with a
passive starter kill device.