Operating instructions

8-2 8-2
Replacement of CD Drive
See also exploded view of changer mechanism.
1. Dismantle printed circuit board: remove 5 screws.
2. Disconnect flexfoil cable and JST connector.
Pay attention to WARNING!
3. Loosen 2 screws (pos 107,108) and remove CD drive-
lockings (pos 105,106).
4. Turn gearwheel (pos 42) of disc change mechanism by
finger to move CD drive support in upper position as
shown in picture below A.
5. Dismantle CD drive support (pos 95) B.
6. Replace CD drive (pos 100). The wire tree of JST
connector has to be desoldered and resoldered on the
new CD drive again.
Service Hints
A
B
Mounting of Carousel
1. Turn gearwheel (pos 42) of disc change mechanism by finger until CD drive is in play position.
2. Mount carousel (pos 115) so that disc is positioned right on turntable. Carousel position number doesn´t matter.
Lubrication Instructions
Grease
Grease inside grove
Grease on top of rib
Grease
Grease on top
of highest ring
Grease on four
rectangular surfaces
Grease inside
groves
Grease on slide
Grease on four
profile groves
CHASSIS
DRAWER