User manual

SETTINGS
4 July 2012 / WPC / EN
2 WPC – PSCP: QUICK START GUIDE
The remote control RCC gives you access to a many settings possibilities. However, in most cases the
setting of two parameters only is required for the perfect running of your installation.
2.1 SETTING OF THE LANGUAGE
To begin, set your remote control PSPC / RCC for a display of the information in English.
The basic display is:
Press 1 time on the key “arrow downwards” to display the following
screen:
Once beyond this screen you can come back to it by means of the
key ”arrow upwards”.
Press the key SET to enter the remote control settings. The screen
of the language choice appears.
Press once more the key SET to modify the current language. The
language then appears in reverse video.
With the keys “arrow upwards” and “arrow downwards” choose the language you wish. Then validate your
choice by means of the key SET (OK).
We can now leave the setting of the remote control with the key ESC.
2.2 ADAPTATION TO THE SOURCE
It is a matter of indicating to the WPC the power available to charge the batteries and to supply the users.
In order to adapt your installation to the source it is connected to, proceed as follows:
The basic display is:
Press 2 times on the key “arrow downwards” to display the
following screen:
Once beyond this screen you can come back to it by means of the
key ”arrow upwards”.
Press the key SET to access to the settings.
Then again on the key SET to access to the basic parameters.