User`s guide

9 - 6
Symbologies Section
The Symbologies section specifies the settings for each of the symbologies supported by the decoder. 1D symbologies are
available in ScanWedge.exm, and both 1D and 2D symbologies are available in ScanManWedge.exm. Double tap on the
symbology name to display the default value, and the settings for that symbology.
The settings are in the form:
Symbology Name=Enable(1 or 0), Parm1, Parm2, Parm3, Parm4, Parm5, Parm6, Parm7, Parm8
Where
• Enable specifies that the symbology is enabled or disabled.
• Parms1–8 specify the settings for the symbology.
To see For more information regarding the individual settings for each of the symbologies, refer to the Honeywell Decode
API documentation in the SDK documentation.
OCR
For comprehensive information about using OCR, refer to the OCR Programming User’s Guide available on our website at
www.honeywellaidc.com.
VK (Virtual Key) Mapping Section
The virtual key map settings are located in the VKMapping section in the ScanWedge or ScanManWedge configuration file.
The virtual key map settings define the virtual key that will be sent to ScanWedge or ScanManWedge for any decoded
ASCII character.
The settings are in the form: ASCII Key = Virtual Key, ShiftMode
Where
• ASCII Key is an ASCII value between 0 an 255 (decimal)
• Virtual Key is the virtual key to be sent when the specified ASCII key is decoded
OCR MICR (E 13 B) O (0x4F)
OCR SEMI Font O (0x4F)
OCR-A O (0x4F)
OCR-B O (0x4F)
PDF417 r (0x72)
Planet Code L (0x4C)
Postal-4i N (0x4E)
Postnet P (0x50)
QR Code and Micro QR Code s (0x73)
Straight 2 of 5 IATA f (0x66)
Straight 2 of 5 Industrial f (0x66)
TCIF Linked Code 39 (TLC39) T (0x54)
Telepen t (0x54)
UPC-A c (0x63)
UPC-A with Add-On c (0x63)
UPC-A with Extended Coupon Code c (0x63)
UPC-E E (0x45)
UPC-E with Add-On E (0x45)
UPC-E1 E (0x45)
Symbology Code ID (hex)