User`s guide

9 - 2
ScanWedge.exm or ScanManWedge.exm Sections
Double tap or click on any Key to get full information or to edit the settings in the ScanWedge.exm or ScanManWedge.exm file.
Data Formatting Reference Charts
ASCII Conversion Chart (Code Page 1252)
Note: This table applies to U.S. style keyboards. Certain characters may differ depending on your Country Code/PC
regional settings.
Section Description
Settings
Programs general settings for ScanWedge or ScanManWedge.
Comm
Specifies how the serial (RS-232) port interfaces with ScanWedge or ScanManWedge.
Decode
Specifies how the decoder/scanner interfaces with ScanWedge or ScanManWedge.
Formatting
Defines data formatting functionality.
Symbologies
Defines the symbologies that the scanner can decode and send to ScanWedge or ScanManWedge.
VK Mapping
Defines the virtual key sent to ScanWedge or ScanManWedge for any decoded ASCII character.
Non-Printable Characters
DEC HEX Character (Code) DEC HEX Character (Code)
0 0 NULL 16 10 DATA LINK ESCAPE (DLE)
1 1 START OF HEADING
(SOH)
17 11 DEVICE CONTROL 1 (DC1)
2 2 START OF TEXT (STX) 18 12 DEVICE CONTROL 2 (DC2)
3 3 END OF TEXT (ETX) 19 13 DEVICE CONTROL 3 (DC3)
4 4 END OF TRANSMISSION
(EOT)
20 14 DEVICE CONTROL 4 (DC4)
5 5 END OF QUERY (ENQ) 21 15 NEGATIVE ACKNOWLEDGE-
MENT (NAK)
6 6 ACKNOWLEDGE (ACK) 22 16 SYNCHRONIZE (SYN)
7 7 BEEP (BEL) 23 17 END OF TRANSMISSION
BLOCK (ETB)
8 8 BACKSPACE (BS) 24 18 CANCEL (CAN)
9 9 HORIZONTAL TAB (HT) 25 19 END OF MEDIUM (EM)
10 A LINE FEED (LF) 26 1A SUBSTITUTE (SUB)
11 B VERTICAL TAB (VT) 27 1B ESCAPE (ESC)
12 C FF (FORM FEED) 28 1C FILE SEPARATOR (FS)
RIGHT ARROW
13 D CR (CARRIAGE RETURN) 29 1D GROUP SEPARATOR (GS)
LEFT ARROW
14 E SO (SHIFT OUT) 30 1E RECORD SEPARATOR (RS)
UP ARROW
15 F SI (SHIFT IN) 31 1F UNIT SEPARATOR (US)
DOWN ARROW