Service manual

Operating Procedures
Illustration
(6) Remove the compressor and
gas-liquid separator
1） Remove the compressor
● Loosen the insert on the electrical
terminal of the compressor. (See Fig.
20)
●Loosen and remove the spring fixing the
auxiliary electric heater of the
compressor. Remove the electrical
connections. (See Fig. 19).
●·Cut the suction and exhaust pipe of the
compressor. (See Fig. 21)
● Loosen the nuts fixing the compressor.
Remove the compressor.
Fixing spring
Fig.19
Fig.20
Fig.21
63