Service manual

Operating Procedures
Illustration
● Loosen the screws fixing the motor to
the motor support. Pull backward to
remove the motor. (See Fig. 10)
● Loosen the motor wire plug, and insert
the motor wire through the cable-cross
hole.
(4) Remove the 4-way valve and
capillary
1. Remove the 4-way valve
● Loosen the screws fixing the
electromagnetic coil on the 4-way
valve.
● Remove the electromagnetic coil.
● Cut the weld between the 4-way valve
and other pipes.
● Remove the 4-way valve. (See Fig.
11)
Note: When cutting the weld, take care
to prevent the flame from touching other
parts. The valve body shall be
completely wrapped with wet cloth in
order to avoid damage under high
temperature.
2. Remove the capillary
● Cut the two welds between capillary
and other pipes.
●Remove the capillary. (See Fig. 12)
Fig.10
Fig.11
Fig.12
49