Operating instructions
1
Safety
1.1
General safety instructions
The devices must only be operated for the intended use under
the conditions stated in this operating manual. Any other type
of operation is considered to be non-intended use and can
impair the protection provided by the device.
The operating manual is part of the device. The information in
this operating manual must therefore be available in the imme-
diate vicinity of the device. Also keep this copy of the operating
manual carefully.
If you lose this operating manual, contact the LAUDA
Constant Temperature Equipment service. The contact
details can be found in
Ä
Chapter 13.4 ‘LAUDA contact’
on page 94.
Use of the device results in hazards from high or low temperatures
and from the use of electrical energy. The hazards of the device
are eliminated as much as possible by the design in accordance
with the appropriate standards. Residual hazards are reduced
using any of the following measures:
If relevant, there are safety devices for the device. These
devices are essential for the safety of the device. Their func-
tionality must be ensured with appropriate maintenance activi-
ties.
The safety devices of the device are described in this "Safety"
chapter.
If relevant, there are warning symbols on the device. These
symbols must always be observed.
The warning symbols on the device are described in this
“Safety” chapter.
There are safety instructions in this operating manual. These
instructions must always be observed.
There are additional specific requirements for the personnel
and for the personal protective equipment.
These requirements are described in this "Safety" chapter.
An overview of the authorised personnel and the protec-
tive equipment can be found in
Ä
Chapter 1.9 ‘Per-
sonnel qualification’ on page 10 and
Ä
Chapter 1.10
‘Personal protective equipment’ on page 10.
Further information about the general structure of safety
instructions can be found in
Ä
Chapter 1.12 ‘Structure
of the safety instructions’ on page 11.
Safety
Variocool 7