Operating instructions

6.4 Switching on the device
Personnel:

Operating personnel
1. Switch on the device using the mains power switch.

A signal tone sounds.
Further information about switching on can be
found in
Ä Chapter 5.3.2 ‘Switching on and
filling device’ on page 35.
2. The basic window is displayed.
After switching on, the device defaults to the standby
operating mode if the
start operating mode is not set to
on . Changing the start operating mode can be found in
Ä Chapter 6.11.4 ‘Specifying starting mode (Autostart)’
on page 55.
6.5 Screen displays
6.5.1 Basic window
The basic window is displayed after switching on the device. The
basic window contains different components depending on the
operating mode.
1 Expanded status display
2 Status display
3 Internal actual temperature Tint (depending on set control vari-
able, the external actual temperature Text is also displayed
here)
4 Softkey bar
1 Level indicator
2 Heater is active and heats with the displayed percentage of
total power. This display is only available if the device is
equipped with the optional heater.
3 Cooling is active and cools with displayed percentage of total
cooling capacity.
4 Display of date and time
Fig. 14: Basic window
During normal operation
Fig. 15: Basic window structure
Fig. 16: Expanded status display
Operation
Variocool 42