Operating instructions

WARNING!
Spraying of heat transfer liquid
Electric shock
 Avoid spraying heat transfer liquid. Use a funnel for
filling.
1. Close the drain tap. Turn the lever to the left for this.
2. Switch on the device using the mains power switch.
For VC 600 to VC 3000 (W), press the mains
power switch to the position
[1].
For VC 5000 (W) and higher, turn the mains
power switch to the position [1].

A signal tone sounds.
The type designation and version numbers of the soft-
ware available as standard in the device are shown in the
display for approx. 5 seconds. If device options are con-
figured, these are also displayed.
You can retrieve the version numbers of the
software available in the device at any time
using the menu.
Operation outdoors for outdoor tem-
perature below 5 °C
Warnings are displayed on the screen
showing the duration of the preheating time of
the compressor or that the compressor should
be preheated. If the compressor is not pre-
heated, this can result in increased device
wear or material damage in the cooling
system! Further information can be found in .
3. The window for selection of the menu language is displayed
on the screen. Select the required menu language using the
UP and DOWN arrow buttons. Confirm your selection with
the OK button.
For example, select Deutsch to see display
entries in the German language.

The fill mode is started.
4. Pull up the cover of the filler nozzle.
Fig. 8: Start screen
Fig. 9: Menu language
Commissioning
Variocool 36