Owner manual

2
TOOL REQUIREMENTS
There are some other items you might want to consider that will help you with the installation. These
are:
Cables/Chain with 1000 Lb lifting capacity
Chain fall or Come-a-long
Fork Lift
Sledge Hammer
Safety Glasses Hard Hat (if job requires)
5/16” Hex head driver bit for TEK screws
Allen wrenches to 3/8” Hammer
“C” Clamps Hammer Drill & Bits
Carpenter Square 4’ Level
Chalk line 25’ Tape Measure
4” Angle grinder Slip joint pliers
Drift punches Open End wrench set to 3/4”
Drill Bits to 3/8” Screw Driver set (flat and phillips)
Electric drill Socket set, 1/4” & 3/8” drives
Hack Saw (or Port a Band) Taps & tap wrench to 3/8”
Extension cords Welding Equipment