User guide
Page 1-4 P/N. 11016-001 Rev. January 7, 2005
User Guide
AutoPulseâ„¢ Resuscitation System Model 100
1.3.4 AutoPulse Power System Battery Charger
The AutoPulse Power System Battery Charger (also known as the Battery Charger) is a stand-alone unit
intended to charge and test-cycle the Batteries. The Battery Charger has two charging bays; each with its
own indicators. The Battery Charger automatically maintains both the state of charge and tests and
maintains the Battery to its highest possible capacity. Batteries should always be fully charged and ready
for use before deploying the AutoPulse Platform.
For more information on the Battery Charger, refer to the AutoPulse Power System User Guide.
1.4 User Controls and Indicators
1.4.1 ON/OFF Button
The ON/OFF button is located adjacent to the Battery on the AutoPulse Platform (see Figure 1-3).
Pressing the ON/OFF button once powers up the AutoPulse Platform and initiates a self-test. The User
Control Panel’s green Power LED lights up. Pressing the ON/OFF button again powers down the
AutoPulse Platform.
Figure 1-3 ON/OFF Button Location
1.4.2 User Controls
All user controls and indicators (except the ON/OFF button) are contained in User Control Panel (see
Figure 1-4).
ON/OFF button
User Control Panel