Installation Manual
7
CUSTOMIZING YOUR LIGHTING LAYOUT
PROBLEM CHECK SOLUTIONS
Screen does not work aer
connecng power supply
Check if the power supply/
adapter/controller works
normally
Unplug DC connector from the
controller momentarily then
reconnect taking care to ensure
the connector is fully inserted
and ghtened
Controller does not control xtures
Check if the signal cable is
connected well and is fully
inserted/locked; check pin
condion
Reconnect the signal cable and
go xture by xture to idenfy
communicaon loss point
Controller does not show
temperature aer connecng with
temperature probe
Check if the temperature
probe is inserted fully
Disconnect and reconnect the
temperature probe
Fixture status is dierent from the
power set by controller
Check if the xture is under
sunrise and sunset mode or
if the temperature is under
temperature protecon mode
Adjust the me of sunrise and
sunset or reset the temperature
limits
When connecng several xtures,
the rst several xtures work
normally, while the following
xtures funcon abnormally
Check if the signal cable is
connected well, or if the
pins of the connectors are
damaged, or the LED status
on xtures
Reconnect the signal cable, or
replace any damaged xture
Fixtures fail to turn o
Check xture quanty per
zone. Too many xtures will
cause residual voltage in the
cable system.
Reduce number of xtures per
zone
TROUBLESHOOTING
See pages 8–23 for data link cable guides that show you how to customize your lighng setup
with the same or mulple lighng technologies within the same environment.
LED Fixtures ............................................................8
HID Fixtures
Phantom with USB .................................................10
Core 2.0 ..........................................................12
Mulple Lighng Technologies
LED + Dual CMH ...................................................14
LED + DE HPS ......................................................15
Dual Zone DE HPS ..................................................16
DE HPS + Dual CMH ................................................20
DE HPS + DE MH ...................................................22